Combi Flash 7650 Series Bedienungsanleitung PDF herunterladen (Seite 27)

Section 2 Preparation

2-7

a. Locate a nut (60-0923-015) and ferrule (60-0083-163) in

the accessory package (60-5249-002).

b. Insert the ferrule, narrow end first, into the A LEVEL

port.

c. Loosely thread the nut onto the A LEVEL port.

d. Insert the Solvent A air line into the A LEVEL port

until it is fully seated.

e. Finger-tighten the nut. If desired, tighten the nut an

additional

2 turn using a wrench.

4. Locate the Solvent B inlet line. This assembly consists of

three tubes fastened together—a solvent line, a smaller

diameter air line, and a solvent prime line.

5. Connect the large fitting on the Solvent B inlet line to the

Torrent’s B INLET port as described in step 2.

6. Connect the smallest tube of the Solvent B inlet line to the

B LEVEL port as described in step 3.

7. Connect the remaining tube of the Solvent B inlet line to

the B PRIME port:

a. Finger-tighten the pre-swaged fitting to the port labeled

B PRIME.

b. Use a wrench to tighten the fitting an additional

8

turn.

The other ends of the Solvent A and B lines should be placed

in the respective solvent containers. If using the optional

Solvent Inlet Cap sets (60-5394-510 for 83B closures,

60-5394-511 for 100 mm closures), proceed with the following

steps:

8. Screw the cap onto the carboy.

9. Feed the solvent line assembly through the hole in the cap.

The weighted inlet should rest at the bottom of the

container.

2.6.2 Teledyne Isco Pressurized Canisters

Pressurized canisters from Teledyne Isco support Torrent’s the

solvent level sensing feature. To complete the solvent

connections, refer to the instruction sheet provided with the

pressurized containers.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 158 159

Keine Kommentare

Combi Flash 7650 Series Bedienungsanleitung Seite 27